![]() ![]() Locking thread is the one that is easier to pull out. Only the locking thread in both directions, stitch at a time. The opening and, with a blunt awl like a knitting needle, pull out One of the threads makes a zigzag as it locks the other thread where Don't cut off the freeĮnd, because it is often good enough to re-sew the seam. Last loop and pull tight, to lock the zipper. When enough seam is open, thread the loose end through the ![]() WhenĮnough thread is free to pull on, the stitching can be opened like a Out several stitches in the direction the stitch pattern points. Intended opening and with a blunt awl, like a knitting needle, pull Tools for tubular repair, scissors and razor blades being commonĬut the thread at some convenient place at the upstream end of the Triangular sewing needle from a Velox patch kit are two highly useful Seam Ripper and Triangular NeedleĪ convenient tool, available in the sewing department at mostĭepartment and sewing specialty stores, is a seam ripper. Tape with latex emulsion, allow to partially dry, and put the tape in Paint theĮxposed casing zone that is to be covered by the base tape and the Use latex to glue down loose threads on a sidewall cut. On one side of the stem, preferably the side where machine finished. Stitching, because it takes more time to pull out the cut thread than It to one side or separate it where it is overlapped. Never cut the base tape, because it cannot be butt joined. Location of the cut or rupture, about the length of the boot (at least To insert a boot requires an opening of about 6 to 10 cm at the ![]() Even if there are two punctures not tooįar apart, the tube can be pulled out of a nearby opening. Remember, the tube is elastic and can be pulled a long wayįrom a three-cm long opening. Never open more tire than is necessary to pull the tube out of theĬasing. Make a pattern of slanted arrows that point in the direction in which Zipper stitch is identified by having only one thread. Of seams, zipper stitch (using one thread) and two-thread stitch. Toĭo this, open the casing by peeling the base tape back and unstitching The tire casing must be opened to gain access to patch the tube. More Articles by Jobst Brandt Next: Cassette or Freewheel Hubs Previous: Tubular Fables ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |